KU LNC 8085 C PRO 2

KU LNC 8085 C PRO2, Low Noise Converter

Converter for Deep Space Communication with 10 MHz reference input

Finally available:
The X-Band Super Low Noise Converter KU LNC 8085 C PRO2 with 10 MHz reference input.
For an improved Deep Space Communications application!
Available from stock
Frequency range (RF)8000..8500 MHz
Maximum input power1 mW (0dBm)
Frequency range (IF)200..1300 MHz
Noise figure @ 18 °Ctyp. 0.8 dB, max. 1.0 dB
Gain @ 25 °Ctyp. 50 dB (high gain), typ. 37 dB (low gain)
Output IP320 dBm
LO frequency7200 MHz, 7400 MHz, 7600 MHz, 7800 MHz
LO accuracy @ 18 °C1 kHz
LO frequency stability0.5 ppm
Phase noise @ 1 kHztyp. -90 dBc/Hz
Phase noise @ 10 kHz-94 dBc/Hz
Phase noise @ 100 kHztyp. -105 dBc/Hz
External reference input10 MHz / 2 ... 10 mW
Supply voltage+9 ... +36 V DC
Current consumptiontyp. 250 mA @ 12V DC
Maximum case temperature+55 °C
Input connector / impedanceSMA-female, 50 ohms
Output connector / impedanceSMA-female, 50 ohms
Casemilled aluminium, IP43
Dimensions (mm)82 x 64 x 22
Weight230 g
Remote power supply via IFFERNSPEISUNG
The LNC 8085 C PRO2 converts the HF range of 8 ... 8.5 GHz into the IF range of 200 ... 1300 MHz.

Four LO frequencies 7200/7400/7600/7800 MHz are permanently stored. In addition, you can control your individual IF range with a LO frequency programmable in 10 MHz steps. The possibility of connecting a 10 MHz reference source also makes it possible for the first time to ensure frequency stability for long-term applications.

Two gain levels can be set: In addition to the low gain stage of typ. 37 dB, a high gain stage of typ. 50 dB is integrated especially for Deep Space users.

The robust and weatherproof design stands for the high-quality workmanship of Kuhne electronic.
  • Low noise figure
  • Wide bandwidth
  • Low phase noise
  • High frequency stability of the oscillator due to 10 MHz reference input
  • High linearity
  • Antenna connection protected against static charging
  • Easy mast mounting due to light and compact design
  • Three-colour LED indicates unit status and gain mode setting
  • Gain mode setting
  • Overvoltage protection and reverse polarity protection - Remote power supply via output connector
  • Deep Space Communications
The total gain of pre-amplifier + attenuator + converter should not exceed 60 dB.

Accessories

References