KU PA 040050-10 HY, MOSFET-Leistungsverstärker

KU PA 040050-10 HY, MOSFET-Power Amplifier

400 ... 500 MHz • 10 W
Available from stock
Frequency range400..500 MHz
Input power for P3dBtyp. +13 dBm
Maximum input power+17 dBm
Output power P1dBtyp. 40 dBm, min. 37 dBm (CW)
typ. 10 W, min. 5 W (CW)
Output power P3dBmin. 40 dBm (CW)
Output power P3dBmin. 10 W (CW)
Gain (small signal)min. 30 dB
Gain flatness (small signal)typ. +/- 2 dB
Harmonic rejection min. 50 dB @ 40 dBm
IM3 (1)typ. 35 dBc, min. 27 dBc @ 37 dBm PEP
Efficiency min. 22 % @ 40 dBm (CW)
Input return loss (S11)min. 10 dB
ON voltage+12 V DC
Supply voltage+12 ... 14 V DC
Quiescent currenttyp. 2 A
Current consumption @ P3dBtyp. 2.5 A
Forward detectionyes (diode detector)
Operating case temp. range-20 ... +55 °C
VSWR of loadmax. 1.8 : 1
Input connector / impedanceSMA-female / 50 ohms
Output connector / impedanceSMA-female / 50 ohms
Casemilled aluminium
Dimensions (mm)130 x 60 x 20
Weight270 g (typ.)
(1)Measured 2-tone, frequency spacing: 1 MHz
  • Built-in low pass filter for good harmonic rejection
  • Good linearity
  • Reverse polarity protection
  • Monitor output for forward power detection
  • Analog transmission systems
Please notice the following:
  • The technical specifications refer to room temperature.
  • The power amplifier doesn’t contain any coaxial relays.
  • The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
  • Further information about dimensioning of heat sinks is available on our FAQ site.

Accessories

References