KU PA 340360-4 A, Leistungsverstärker
KU PA 340360-4 A, Leistungsverstärker KU PA 340360-4 A, Blockdiagramm

KU PA 340360-4 A, RF Power Amplifier

'.3 Jahre Garantie / 3 years guarantee.'
'.Isolator / Ausfallsicherheit / reliability.'
'.Kühlung auf Anfrage / cooling on request.'
3400 ... 3600 MHz • 4 W

This power amplifier provides high linearity. An isolator at the output protects the semiconductor devices from reverse power. Very good harmonic rejection is achieved. Two detector outputs allow permanent monitoring of forward and reverse power. Typical applications of this amplifier are digital broadcast and communication systems like Digital Video Broadcast (DVB) or Digital Multimedia Broadcast (DMB). The amplifier contains an automatic level control (ALC). The desired output power can be adjusted continuously, from nearly zero to the maximum output power.
Lead time on request
Frequency range3400..3600 MHz
Input power for P1dBtyp. -12 dBm
Maximum input power+10 dBm
Output power P1dBmin. 36 dBm (CW)
min. 4 W (CW)
Output power COFDM (1)typ. 31.7 dBm, min. 30 dBm
typ. 1.5 W, min. 1 W
Automatic level control (ALC)yes (adjustable ALC)
Gain (small signal)typ. 46 dB
Gain flatness (small signal)typ. +/- 2.5 dB
Harmonic rejection typ. 60 dB, min. 52 dB @ 36 dBm
VSWR protectionIsolator
IM3 (2)typ. 45 dBc, min. 41 dBc @ 30 dBm PEP
Efficiency typ. 14 % @ 36 dBm
Input return loss (S11)typ. 12 dB
ON voltage+5 ... 14 V DC
Supply voltage+11 ... 14 V DC
Current consumptiontyp. 2.5 A
Forward detectionyes (diode detector)
Operating case temp. range-20 ... +55 °C
Input connector / impedanceSMA-female / 50 ohms
Output connector / impedanceSMA-female / 50 ohms
Casemilled aluminium
Dimensions (mm)158 x 60 x 20
Weight310 g (typ.)
(1)Measured with QAM 64, single carrier, EVM: 2%
(2)Measured 2-tone, frequency spacing: 1 MHz
  • GaAs FET technology
  • High linearity (class A operation)
  • Good harmonic rejection
  • Isolator for protection against high VSWR
  • Reverse polarity protection
  • Monitor outputs for foward and reverse power detection (DC voltage)
  • Adjustable ALC (automatic level control)
  • ON / OFF control with DC voltage (ON at 5 ... 14 V DC)
  • Digital broadcast systems (DVB, DMB)
  • COFDM systems using modulation types QPSK, QAM
  • Analog transmission systems
  • With reduced power suitable for DATV (digital amateur television)
Please notice the following:
  • The technical specifications refer to room temperature.
  • The power amplifier doesn’t contain any coaxial relays.
  • The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
  • Further information about dimensioning of heat sinks is available on our FAQ site.

Accessories

References

One of the critical key components of a wireless system is the low-noise amplifier (LNA). The LNA, usually connected close to the antenna, takes the weak radio-frequency (RF) signal from the antenna and amplifies it. The main function of the pre amp is to increase the amplitude of the receiving signal without adding much noise and distortion, in other words, to nearly maintain the signal to noise ratio (SNR)  of the desired RF signal.  The main characteristics of the low noise preamplifier are noise figure (NF), gain, and linearity. KUHNE electronic provides a variety of high quality low-noise and ultra low-noise amplifiers, covering frequency bands L, S, C, X, K, frequency selective and broadband. The functional bandwidth varies from several MHz to about 20 GHz. The website-filter on the product page can be used to refine your search results by frequency range, gain, noise figure and supply voltage. The broad portfolio of KUHNE RF LNAs offers high performance including low noise figure (NF), high gain, high linearity and small power consumption, therewith supports the customers in many different use cases and scenarios, e.g., high and low bandwidth applications, in commercial usage as well as for lab experiments and research. Several application examples are given as follows: the 2 GHz UHF broadband low noise amplifier KU LNA BB 2227 A can be used in the RF front end of a multitude of wireless standards in the ISM band, like UMTS, bluetooth, radar, or 2.4 GHz Wi-Fi, e.g., supporting the communication and video transportation in sports events. Another example is the 5-6 GHZ RF linear preamp KU LNA 5059 A, which is needed in IEEE 802.11a/n/ac Wi-Fi systems operating in the 5.1-5.85 GHz range. Other applications like Automatic Dependent Surveillance Broadcast (ADS-B): KU LNA 1090-2 A, Multichannel Multipoint Distribution Service (MMDS): KU LNA BB 2227 A, Radio astronomy: KU LNA 142 AH, Satellite Communication (Satcom) systems: KU LNA 152 AH and so on can be found in the product descriptions. KUHNE electronic also focuses on the dynamic demands of markets and provides most up-to-date customized solutions. We offer low-noise amplifiers (LNAs) with special features, such as different connector types (SMA, N, Waveguide, and many more), remote power supply via coaxial cable, waterproof cases and so on. Our professional RF products and components enable optimum measure, test, and field application experience.